5L Single Pack Polyurethane Gloss paint available in Blue, black, green, red, yellow, British Racing Green and orange, Silver and Matt Black. We only sell 5L tins Do NOT sell 1L or 2.5L.This multi-Purpose Enamel Paint is based on a white spirit polyurethane enamel resin, suitable for brush, roller and spray applications and will provide a high gloss(except Matt Paint), water proof finish with good chemical resistance. Touch Dry in 2-4 Hours. Full Dry in 7 Days. Provides Good chemical resistance with a gloss finish (except Matt Paint Obviously).
For indoor & Outdoor use (please ensure adequate ventilation for indoor use). Use straight out of the tin. Suitable but not limited to use on Wood, metal, concrete, brick & stone, vehicles, marine vehicles (above & below waterline), farm machinery, skips, garden furniture/decking along with other suitably prepared and primed substrates.
Recommendations are a general guide and in no way set in stone. Generally, it's down to personal preference.
Applying with a pot gun. Use a 1:4 to 1:8mm tip set up thinning by 10% if required. Hardener can also be applied.
Applying with an air assisted or air assisted airless system. Use a 13-15 thousandths tip (thinners usually not required). If thinning is necessary use around 10% thinner to paint.When spraying, Hardener can also be applied. We recommended two coats of paint for the best, longest lasting finish. Applying by Brush or Roller. Used straight out of the tin. Thinning is not usually required but if you 10% is recommended.
Recommended Thinner: T0001 White Spirit. Good preparation is paramount to an excellent long lasting finish.
We do not currently stock or supply thinner, hardener or primer. These can be acquired from your local car spares supplier or DIY store. Approximately 8-10 squared meters per litre. We cannot be held responsible for the method of application, absorption of substrate or wastage. Mix paint well before use and check colour before use.Make sure substrates are suitably prepared (lightly abraded, degreased and or primed). When applying to pre-painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to provide good intercoat adhesion. AB31-AB56, IV, KW1-KW14, PA21-PA40, PH8-9, PH15-PH40, PH49-PH51, SE, FK19-FK21, IV63.
Any questions, please do get in touch. This item is in the category "Home, Furniture & DIY\DIY Materials\Paint, Stain & Varnish\Interior & Exterior Paint". The seller is "marque1trading" and is located in this country: GB.
This item can be shipped to United Kingdom.