Step Paint Front Door Back Door for Concrete Stone Wood Primed Metal and Brick

  

C Paints Ltd do it right First Time Every Time. Hard Wearing Single Pack Polyurethane Step Paint is a White Spirit based paint is not only suitable for Concrete but also Metal, Wood, Stone, and Brick floors which light to medium foot traffic will occur. This product offers a good chemical resistance which can also be used as a dust sealer.

This product is a high gloss finish. This product is NOT suitable for tiles of any sort. Can be brushed, roller or spray applied. Thinners suitable T0001 White Spirit. 8 square metres per litre.

(this does not account for the method of application, absorption of substrate or wastage). Light to medium foot traffic (Two pack epoxy floor paint is requiored for vehicles). Make sure you use a mixer on a slow running drill, pallet knife or a broom stick that reaches the bottom of the can and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.

Thinners required are White Spirit T0001. If thinning is required when applying by a brush or roller start by gradually adding 5% but do not thin more an 10% as the paint won't cover. As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential. Application - Painting over existing paint. Check suitability of the product. We recommend you try a sample area first. Step 2 Clean and Abrade.

Make sure the existing paint is in good condition prior to painting, then lightly abrade to provide a key for good intercoat adhesion. If there is flaking paint this must be removed prior to painting.

For any parts that has rusted you will need to sand the rust back to the bare metal and spot prime with the appropriate primer. Ensure substrate is clean of any dirt, oil, or grease. Step 3 Prime - This step is down to personal preference, depending on the condition of the existing paint or if you are changing a dark colour to a light you may want to add one coat of primer. Step 4 Topcoat- Once you have completed the following steps you can apply your top coat. Application - Painting a bare substrate.

Step 1 Clean - Ensure substrate is clean of any dirt, oil, or grease. Step 2 Prime - Depending on the material you are painting will determine what primer you will need. Step 3 Topcoat - 12-24 hours after applying the primer you can add your first coat of topcoat. Wait another 12-24 hours and then apply the second coat.

Is based on a polyurethane enamel resin that provides a good hard-wearing coating once fully dry, with a mirror like gloss finish to industrial concrete floors and other suitably primed substrates for internal and external applications. This product is also available in a non slip finish.