It offers effective resistance to fungal degradation on the underside and surface of the primer film, prolonging the life of your paint job. Bulls Eye® 1-2-3 is great for blocking stains.
It permanently and completely seals graffiti, grease spots, tar and asphalt - inside and out. For oil and water stains, fire and smoke damage try our next generation Bulls Eye® 1-2-3 Plus. Bulls Eye® 1-2-3 is rust inhibitive and ideal for new metal.
It resists flash rusting in its "wet" state - and provides rust resistance for the life of the coating. It dries to a smooth, tight, water-resistant film that is perfect for painting iron railings, steel doors, metal panels, duct work, galvanised gutters - any interior or exterior metal surface. Not the product you need? Further Details and Technical Data. Apply Zinsser Bulls Eye 1-2-3 to interior and exterior.Provides a rust inhibitive coating on. Resistant to high pH surfaces (up to 12.5) including. Hot' joint / texture compounds. Seals porous surfaces and traps most stains in the primer film.
Some stains may require a second coat. Shelf Life: 2 years in unopened container. Pack Sizes: 1l / 2.5l. Please refer to the product Data Sheet for more technical information.
Surfaces should be clean, dry, sound and free of dust, dirt, excessive chalky material, grime, grease, oil, wax, mould, wallpaper adhesive or any contamination that may interfere with adhesion. If unsure, always wash surface with a household cleaner, appropriate cleaning solution, or solvent. Clean new galvanised with methylated spirit.Remove any unsoundly adhered coatings. Sand any remaining paint film edges smooth with the surface. New plaster which is polished or dusty should be sealed with Zinsser Gardz®. Lightly sand exposed exterior wood with 80 to 100 grit sandpaper to remove loose or weathered wood fibres.
When priming over stained areas, first attempt to remove as much of the stain as possible by washing, sanding, scraping, etc. Remove mould and treat area with Blackfriar Fungicidal Wash, or Zinsser Mould Killer & Remover. Spot prime knots and sap streaks with Zinsser B-I-N® Primer-Sealer. Ready to use - no dilution necessary. In most cases only one coat is necessary.
Porous surfaces may require two coats to properly seal. Prime entire surface for best results. If thinning is necessary add no more than 10 % clean water and stir thoroughly. Note that thinning the primer may affect its stain blocking properties.
Please refer to the product Data Sheet for further instructions. Clean application tools with warm water and liquid detergent or household cleaner.
Work solution into bristles/nap and rinse well. If Bulls Eye® 1-2-3 dries, use Zinsser BIN Brush Cleaner to remove dried paint on brushes. Dispose of unused or unwanted product in accordance with local laws regulating water-based coatings. Scraping, sanding or removing old paint may release lead dust.Special precautions should be taken during the surface preparation of pre 1960's paint surfaces over wood and metal as they may contain harmful lead. When dry-sanding avoid dust inhalation by wearing a suitable protective face mask. This item is in the category "Home, Furniture & DIY\DIY Materials\Paint, Stain & Varnish\Paint Primers". The seller is "industrialcoatingsltd" and is located in this country: GB. This item can be shipped to United Kingdom.